![]() Make sure you also check out the brand-specific amp controls guide which is relevant to you, to get the most from your rig: Check out my complete guide to amplifier controls to learn how to adjust these controls and many more to get the best settings possible. Some amps also have other controls such as presence and contour. Alternatively, if it sounds muddy then you can turn it up. If you find that the tone is too harsh then it may need to be turned down. I recommend starting with this on 6-7 to begin with. Treble controls the high-end frequencies and is responsible for making the tone sound clear and crisp. Since Slash is the lead guitarist of Guns N’ Roses, you’ll need to have a decent amount of treble. However, if the tone sounds muddy and loose instead of crunchy, then turn it down. If you feel like the tone is too thin, then it may be useful to turn it up slightly. The bass setting is kept moderate for most songs so start with it on 5-6 to avoid the tone becoming too “boomy” and verging on metal. If you have single coil pickups or a Fender amp then this may need to be a bit higher to compensate for the lack of mid-range emphasis with your rig. Some amps have independent treble, bass and mids controls, whilst others will have a single EQ/ tone control which combines them into one control.Īs I mentioned earlier, Slash uses a lot of mid-range in his tone so start with this on 6-7 to make sure the tone is full and doesn’t get lost in the mix. The EQ section of your amplifier shapes the tone. Using a pedal will allow you to easily switch between the tones without having to adjust your amp. Knockin’ On Heaven’s Door and November Rain) Slash uses a clean tone to start with. This is useful because on quite a few songs (e.g. Also, if your guitar has single coil pickups, then you will probably need to increase your amp’s gain setting more.Īlternatively, if you don’t want to use your amps gain, you can use an overdrive or distortion pedal to get your gain. However, if you have a cleaner amp like a Fender, then it may need to be higher. If you have something like a Marshall, Orange or Boss amp then starting at 6-7 is most likely the best option. If you have a tube (valve) amp, then you’ll need to crank it until you achieve a tone which sounds quite overdriven.ĭepending on your amp, the level you’ll need adjust the gain control to will vary. If you have a solid state amp, then use the distorted channel (if your amp has two channels) and start with this on around 6-7 to begin with. In general, Slash uses a decent amount of distortion on most tracks. Let’s take a look at each setting individually to get a good starting point. Depending on your rig, you may need to compensate by increasing the mids and gain setting to achieve this kind of tone. If we take a look at his rig, there are two main constants:īoth these pieces of equipment give Slash plenty of mid-range frequencies and saturation. Before we jump into some example amp settings for specific GN’R songs, it’s a good idea to go through the fundamentals and get an idea of what settings underpin Slash’s iconic tone.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |